Truma Combi Heater 6E - iNet X Panel

The Combi 6 E is a warm air heater with integrated water heater. It differs from the Combi 6 by its integrated electric heating elements. These allow you to run the heater in gas, electric or mixed mode. For stationary use at the campsite, you can operate the Combi heater with the 12 V power supply unit completely without on-board power.

All you have to do is set your personal comfort temperature on the digital control panel. The powerful blowers of the Combi 6 E do the rest. They distribute the warm air evenly throughout the vehicle via four air outlets. If the boiler is full, the water is heated at the same time. In summer, you can also just heat the water without heating. At temperatures below 3 °C, the FrostControl drain valve opens and automatically drains the boiler. The water is drained in bumps, so that the drain does not freeze over.

The Combi 6 E is not only powerful and economical, but can also be installed in any vehicle in a space-saving and flexible way.

This makes the Combi 6E special:

• Lightweight and compact design, thus flexible installation possible
• In hot water mode, water can be heated independently of the heater
• Intuitive operation of the Combi 6 E via digital control panel CP plus iNet ready
• Air conditioning possible in conjunction with a Truma air conditioner
• Currentless drain valve FrostControl integrated

Attention: For the installation of the heater must be mandatory one of the two water sets dazubestellt! (Fir tree connection Art. 721912 or John Guest Art. 721913)

Technical data:

• Energy source: gas & electric
• Nominal heat output: 2000W / 4000W / 6000W
• Nominal heat output: electric operation: 900 / 1800W
• Efficiency: 98%
• Gas / diesel consumption: 160 / 335 / 460 g/h
• Burner power levels: 3
• Operating voltage: 12 V / 230 V
• Air flow rate: max. 287 m3/h
• Current consumption (12V): Average: 1.3 A
• Current consumption (230 V): 900 W 3.9 A / 1800W 7.8 A
• Resting current: 0.001 A
• Water capacity: 10 l
• Water heating time (from approx. 15° to approx. 60°C): Water tank approx. 23 min
• Pump pressure: max. 2.8 bar
• System pressure: max. 4.5 bar
• Weight (without peripherals): 15.5 kg
• Weight (with peripherals): 16 kg
• Installation dimensions LxWxH: 540 x 500 x 350 mm